嵌入式功率为
关键业务连续性
牧师06.30.09_69
NFS110系列
3 5
订购信息
产量
电压
+5.1 V
+12 V
–12 V
–5 V
+5.1 V (IA)
+24 V (I
B
)
(6)
+12 V
–12 V
+5.1 V
15 V
-15 V
-5 V
12 V
15 V
24 V
输出电流
最大
(1)
8 A
4.5 A
0.5 A
0.5 A
8 A
3.5 A
4.5 A
0.5 A
8 A
4 A
0.5 A
0.5 A
7 A
5 A
3.5 A
PEAK
(2)
20 A
9 A
1.5 A
1.5 A
20 A
4.5 A
9 A
1.5 A
20 A
7.5 A
1.5 A
1.5 A
9 A
7.3 A
4.5 A
风扇
(3)
10 A
5 A
1 A
1 A
10 A
4.5 A
5 A
1 A
10 A
5 A
1 A
1 A
9 A
7.3 A
4.5 A
纹波
(4)
50 mV
120 mV
120 mV
50 mV
50 mV
240 mV
120 mV
120 mV
50 mV
150 mV
150 mV
50 mV
120 mV
150 mV
240 mV
总
规
(5)
± 2.0%
± 3.0%
± 3.0%
± 3.0%
± 2.0%
+10/–5.0%
± 3.0%
± 3.0%
± 2.0%
± 4.0%
± 3.0%
± 3.0%
± 2.0%
± 2.0%
± 2.0%
NFS110-7612J
(7,8)
NFS110-7615J
(7,8)
NFS110-7624J
(7,8)
NFS110-7604PJ
NFS110-7602PJ
(6)
Mo½el Nu½½ers
(13, 14, F)
o½el
NFS110-7601PJ
笔记
1
Convection cooled, 80 W maximum.
2
Peak outputs lasting less than 60 seconds with duty cycle less than 10%. Total
peak power must not exceed 110 W.
3
Forced air, 20 CFM at 1 atmosphere, 110 W maximum.
4
Figure is peak-to-peak. Output ripple is measured across a 50 MHz bandwidth
using a 12 inch twisted pair terminated with a 47 F capacitor.
5
Total regulation is defined as the static output regulation at 25 °C, including
初始容差，输入电压规定的限制和输出电压范围内调整
为出厂设置。
6
To achieve stated regulation on the 24 V output on the NFS110-7602PJ, the
以下负载条件必须为真：我
A
/ I
B
≤ 5 ，其中：
I
A
= +5.1 V output current, and
I
B
= +24 V output current
The +24 V output will maintain ±5.0% regulation under the following
附加条件：我
A
≤ 5 A.
7
单输出模型的浮动可能被引用为输出
无论是正或负。较高的电源电压可通过调节
宽的输出电压范围，只要在总输出功率不超过
80 Watts (natural convection) or 110 Watts (forced air).
8
电源故障检测不是单输出型号。
9
Derating curve is application specific for ambient temperatures >50 °C,
for optimum reliability no part of the heatsink should exceed 90 C and no
semiconductor case temperature should exceed 100 C.
10
注意：断开电源后，当允许的最小为1秒
使得热测量。
11
Three orthogonal axes, random vibration, 10 minute test for each axis.
12
本品仅适用于被纳入范围内的其他专业安装
设备并且不能作为单独的产品进行操作。
13
Artesyn Technologies recommends a minimum load of 11 W to achieve the
design MTBF. See the derating curve on page 3.
14
The ‘J’ suffix indicates that these parts are Pb-free (RoHS 6/6) compliant.
15
注意：有些型号不支持的所有选项。请联系您
本地的艾默生网络能源的代表，或使用在线模式
在http://www.PowerConversion.com号码查询工具找到合适的
替代方案。
瞬态响应
NFS110-7601PJ
+5.1 V (7.5 A to 10 A)
+12 V (2.5 A to 5 A)
-12 V (0.5 A to 1 A)
-5 V (0.5 A to 1 A)
+5.1 V (7.5 A to 10 A)
+24 V (1.5 A to 3 A)
+12 V (2.5 A to 5 A)
-12 V (0.5 A to 1 A)
+5.1 V (7.5 A to 10 A)
+15 V (2.5 A to 5 A)
-15 V (0.5 A to 1 A)
-5 V (0.5 A to 1 A)
+5.1 V (10 A to 20 A)
+12 V (4.5 A to 9 A)
+15 V (3.65 A to 7.3 A)
+24 V (2.25 A to 4.5 A)
150 mV peak, 1 ms recovery
100 mV peak, 0.5 ms recovery
100 mV peak, 0.5 ms recovery
100 mV peak, 0.5 ms recovery
150 mV peak, 1 ms recovery
300 mV peak, 1 ms recovery
100 mV peak, 0.5 ms recovery
100 mV peak, 0.5 ms recovery
150 mV peak, 1 ms recovery
100 mV peak, 0.5 ms recovery
100 mV peak, 0.5 ms recovery
100 mV peak, 0.5 ms recovery
250 mV peak, 1 ms recovery
360 mV peak, 1 ms recovery
450 mV peak, 1 ms recovery
720 mV peak, 1 ms recovery
NFS110-7602PJ
NFS110-7604PJ
NFS110-7605J
NFS110-7612J ：
NFS110-7615J
NFS110-7624J
QQ：2880707522 复制
